Kontron AT8901M CLI - Manual (Page 258)

Management Commands AT8901M
AT8901M CLI Reference Manual Page 6 - 6
6.2.4 serial timeout
This command specifies the maximum connect time (in minutes) without console
activity. A value of 0 indicates that a console can be connected indefinitely. The time
range is 0 to 160.
Default 5
Format
serial timeout
<0-160>
Mode Line Config
6.2.4.1 no serial timeout
This command sets the maximum connect time (in minutes) without console activity.
Format
no serial timeout
Mode Line Config
6.2.5 show serial
This command displays serial communication settings for the switch.
Format
show serial
Modes Privileged EXEC
User EXEC
Serial Port Login Timeout (minutes) The time, in minutes, of inactivity on a Serial
port connection, after which the Switch will close the connection. Any
numeric value between 0 and 160 is allowed, the factory default is 5.
A value of 0 disables the timeout.
Baud Rate (bps) The default baud rate at which the serial port will try to connect. The
available values are 1200, 2400, 4800, 9600, 19200, 38400,57600, and
115200 baud. The factory default is 9600 baud.
Character Size (bits) The number of bits in a character. The number of bits is always
8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware
Flow Control is always disabled.
Stop Bits The number of Stop bits per character. The number of Stop bits is
always 1.
Parity Type The Parity Method used on the Serial Port. The Parity Method is
always None.
6.3 Telnet Commands
This section describes the commands you use to configure and view Telnet settings.
You can use Telnet to manage the device from a remote management host.
6.3.1 ip telnet server enable
Use this command to enable Telnet connections to the system and to enable the Telnet
Server Admin Mode. This command opens the Telnet listening port.
Default enabled