Kontron AT8901M CLI - Manual (Page 138)

Routing Commands AT8901M
AT8901M CLI Reference Manual Page 3 - 24
3.6.5.1 no bootpdhcprelay serverip
This command configures the default server IP address for BootP/DHCP Relay on the
system.
Format
no bootpdhcprelay serverip
Mode Global Config
3.6.6 show bootpdhcprelay
This command displays the BootP/DHCP Relay information.
Format
show bootpdhcprelay
Modes Privileged EXEC
User EXEC
Maximum Hop Count The maximum allowable relay agent hops.
Minimum Wait Time (Seconds) The minimum wait time.
Admin Mode Indicates whether relaying of requests is enabled or disabled.
Server IP Address The IP address for the BootP/DHCP Relay server.
Circuit Id Option Mode The DHCP circuit Id option which may be enabled or dis-
abled.
Requests Received The number or requests received.
Requests Relayed The number of requests relayed.
Packets Discarded The number of packets discarded.
3.7 Open Shortest Path First (OSPF) Commands
This section describes the commands you use to view and configure OSPF, which is a
link-state routing protocol that you use to route traffic within a network.
3.7.1 router ospf
Use this command to enter Router OSPF mode.
Format
router ospf
Mode Global Config
3.7.2 enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
Default
enabled
Format
enable
Mode Router OSPF Config
3.7.2.1 no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable