AVer EH6216H+ user manual - Manual (Page 72)

64
 I/O Control: Setup the sensor and relay that is embedded on the IP camera.
 Sensor Setting
1. Click Sensor button.
2. Click the drop-down list and select the sensor ID number.
3. Enter sensor name in Name column
4. The system automatically detects the camera and input relates information. In the Content
section, enter sensor Description.
5. In the test section, click Test to check the sensor status. Red is high and Green is low.
6. Click OK to exit and accept the setting and Cancel to exit without saving the setting.

Relay Setting
1. Click Relay button.
2. Click the drop-down list and select the relay ID number.
3. Enter relay name in Name column
4. The system automatically detects the camera and input
relates information. In the Content section, enter relay
Description.
5. In the test section, click Test to trigger the relay status. Red
is high and Green is low.
6. Click OK to exit and accept the setting and Cancel to exit
without saving the setting.