AVer EH6216H+ user manual - Manual (Page 48)

40
2.2.3.1 Setup the Analog PTZ Camera
1. Select the channel of analog PTZ camera on Preview UI.
2. Click PTZ button from preview UI.
3. In the PTZ control panel, click Setup (see also
Chapter 2.2.3 ).
4. When the PTZ Setup dialog box appears, select the camera number and check the Use PTZ box.
5. In the Connection Settings section, fill in the following selections. Then, click Save to keep the settings.
- COMPort: The port that the PTZ camera is connected
- ID: PTZ camera ID number
- Baud Rate: Please refer to the user ’s manual of the PTZ camera to make sure the baud rate.
- Protocol: Please refer to the user ’s manual of the PTZ camera to make sure what protocol is using.
6. In the Preset Setting section, use the control panel to adjust the position of the PTZ camera and select
the preset number to assign a number for the PTZ camera current position. Set the DwellTime (1-60 sec)
for how long the PTZ camera stays in that position before it moves to the next one. After is done, click
Save to keep the Preset Setting settings.
7. Restore AutoPan Time: set a time period for restoring auto path function after the PTZ camera has been
moved manually. Mark the check box and set the time period in second.
8. Repeat step 4 and 5, if you want to save another PTZ camera position.
9. After finished all configurations, click OK to exit. Click Cancel will exit and without saving the settings.
Use to adjust the
lens of PTZ
camera for preset
position setting.