AVer EH6216H+ user manual - Manual (Page 41)

33
CHAPTER 2
c.
Select the hard disk from device list.
d. Click Format button to start formatting
e. When formatting is done, click OK.
5. Setup the date and time in order to have correct recording time and date. Following the below steps to
setup date and time:
a. Click Setup and enter the password
b. In Date and Time Setting section, click Setting button of System Date and Time.
c. Select the date and adjust the time, and then, click OK.
6. Following the below steps to connect the IP and analog camera.
To connect analog camera
a. Plug the analog camera video cable into DVR video port.
b. Click Setup → Camera
c. Select camera type as Analog Camera.
d. And then, enable the camera.
e. Click Edit button to edit name of camera and enter short description.
f. Adjust the bright, contrast, hue, and saturation of camera.
g. Enable Deinterlace function if necessary.
h. Finally, click OK.
To connect IP camera
a. Click Setup → Camera
b. Select camera type as IP Camera.
c. And then, enable the camera.
d. Click Add IPCam button.
e. Select using Protocol or URL to connect the IP camera. If user chooses the Protocol, please
select mode, video format, resolution, and channel of IP camera. If user chooses the URL,
please enter the complete URL address of IP camera.
f. Enter ID and password if IP camera’s access authority is required.
g. Finally, click OK.
h. To connect another IP camera, follow the above steps.
DVR unit doesn ’t supply the power to connected external devices.
2.1.2 Using the Virtual Keyboard
User can use the Virtual Keyboard when the keyboard is not available. Just click or right-click screen to
call out the virtual keyboard. For uppercase, click Caps button. To exit, click Esc.