AVer EH6216H+ user manual - Manual (Page 103)

95
CHAPTER 3
- Enlarge Camera View
Switch to only display video in Preview mode from
where the alarm is activated.
a. Select the camera from drop down list to specify
which camera video to be enlarged on screen when
the alarm is triggered.
b. Retrieve time: set the waiting duration before
system switching back to original Preview mode. If
the retrieve time is un-set, the alarm video will keep
enlarging until user switch back to Preview mode
manually. The retrieve time range is 0~ 600
seconds.
- Relay Output
Set to enable/disable the relay operation when the alarm is
activated and to extend additional time in second before it
stops the relay operation.
1. Beside the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available
relay list and in the Status column, set to on/off the relay
operation when the alarm is activated.
3. In the Retrieve time check box, you may enable/disable
to extend the relay operation time and set the duration in
second(0 ~ 3600 seconds).
4. Click OK to exit and accept the setting and Cancel to
exit without saving the setting.
- IP Camera Relay: Set to enable/disable the relay operation when the alarm is activated.
- Play Warning Sound
Play alarm sound.