AVer EH6216H+ user manual - Manual (Page 102)

94
 Network is switched off: when the network connection of DVR system is lost, the system will
send out the alarm message.
 Hard Disk failed: when the hard disk doesn ’t work normally, the system will send out the alarm
message.
7. In (5) Alarm Reset, click the camera number to set the reset condition of alarm. Once alarm is reset, all
alarm action will stop at the moment. If the sensor normal status is high, set the alarm reset condition to
low.
- IP Camera Sensor: To adjust sensor high/low that is connected on the IP camera.
- Alarm Reset Time: Set a time for the alarm auto reset. When an alarm happen such as motion
detected and video loss, the alarm will reset at the alarm reset time.
8. In (6) Action, you may now set the alarm action for the system to perform when the alarm condition is
activated.
- Launch E-Map: Display mini E-map screen.
- Spot Monitor
When the DVR system receives the alarm, the alarm video will display on spot monitor.
Mark Spot Monitor 1/Spot Monitor 2 to enable the sport monitor function. And then, select the camera
(channel) when the DVR system receives the alarm from the selected camera will display the alarm
video on the spot monitor.
 Restore to normal display after: Mark to enable and set the time that screen display returns to
normal display after spot display.