Dell C3760dn Color Laser Printer - Manual (Page 70)

68 Connecting Your Printer
Turning on the Printer
WARNING: Do not use extension cords or power strips.
WARNING: The printer should not be connected to an Uninterruptible Power Supply (UPS) system.
1 Connect the power cable to the power connector on the rear of the printer, and then to a power source.
2 Turn on the printer. When the printer is connected via a USB (Uninterruptible Power Supply) cable, the USB
driver is automatically installed.
Setting Initial Settings on the Operator Panel
You need to set the printer language, time zone, clock date, and time when you turn on printer for the first time.
When you turn the printer on, the wizard screen to perform the initial setup appears on the operator panel. Follow
the steps below to set the initial settings.
NOTE: If you do not start configuring the initial settings, the printer automatically restarts in three minutes. After that, you can
set the following initial setup by enabling Power on Wizard on the operator panel or Dell Printer Configuration Web Tool
if needed.
For more information on operator panel, see "Operator Panel."
For more information on Dell Printer Configuration Web Tool, see "Dell™ Printer Configuration Web Tool."
1 The Please Select Language appears. Press the button until the desired language is highlighted, and then
press the (Set) button.
English
Français
Italiano
Deutsch
Español
Dansk
Nederlands
Norsk
Svenska