Dell C3760dn Color Laser Printer - Manual (Page 168)

166 Dell™ Printer Configuration Web Tool
IPsec
Purpose:
To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the
printer.
Values:
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the IPsec menu on the operator panel.
Issuer Displays the issuer to certificate.
Serial Number Displays the serial number of the device.
Public Key Method Displays the public key method.
Size of Public Key Displays the size of public key.
Valid From Displays the time the certificate is valid.
Valid Until Displays the time the certificate is invalid.
Status Displays whether certificate is valid or not.
Certificate Purpose Displays the purpose of certificate.
Certificate Selection
Status
Displays the type of device certificate you selected.
E-mail Address Displayed only when an e-mail address is specified in the certificate.
Use this certificate *2 Click to apply this certificate to the device.
Delete Click to delete this certificate.
Export This
Certificate *2
Click to export the certificate to the other device.
*1 This item is available only when the self-signed certificate has been generated.
*2 This item is displayed only when the optional hard disk is installed and is set to On for encryption.
*3 This item is effective only when connected via SSL/TLS (https). Only the administrator is allowed to display the pages.
*4 This item is displayed only when the optional hard disk is installed and is set to On for encryption. If not, Certificate Details is displayed.
IPsec Settings Protocol Select the check box to enable the protocol.
IKE Sets IKE authentication. Device Certificate is displayed on the list only
when an effective digital signature is set up.
Pre-Shared Key Sets a shared key. Up to 255 alphanumeric characters, periods, and
hyphens can be used.
Re-enter Pre-Shared Key Enters the shared key again to confirm it.
Device Certificate *1 Displays the device certificate.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800 minutes.
IPsec SA Lifetime Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
DH Group Sets the DH group.
PFS Select the check box to enable the PFS setting.
Remote peers IPv4 address Sets the IP address to connect to.
Remote peers IPv6 address Sets the IP address to connect to.
Non IPsec communication
policy
Allows communication with a device which does not support IPsec.
*1 This item is effective only when the optional hard disk is installed and is set to On for encryption.