Canon BJ-30 - Manual (Page 123)

Chapter 7 Troubleshooting 115
Problem Cause Solution
Print Manager problems The drive that contains Canon recommends that the
occur the TEMP directory drive have from 5 MB to
may not have enough 10 MB available.
available space.
To verify a proper TEMP
statement, follow these steps:
1. Exit Windows and go to
the MS-DOS prompt.
2. Type SET at the MS-DOS
prompt. A list of
statements should
appear; look for the
statement that says
TEMP = C:\WINDOWS .
3. If the statement exists,
verify that the directory
exists by typing in the
drive and directory
location with the DIR
command. For example:
DIR C:\WINDOWS
4. If the FILE NOT FOUND
message appears, then
one of the following has
occurred:
❏ You may have typed
the path incorrectly;
make sure the path is
correct.
❏ The directory does
not exist; edit the
AUTOEXEC.BAT file
and change the
directory to a valid
directory; for
example:
SET TEMP =
C:\DOS
Troubleshooting