Dell POWEREDGE M1000E - Manual (Page 340)

11-12
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 11 Configuring Interface Characteristics
Using Interface Configuration Mode
Beginning in privileged EXEC mode, follow these steps to define an interface range macro:
Use the no define interface-range macro_name global configuration command to delete a macro.
When using the define interface-range global configuration command, note these guidelines:
• Valid entries for interface-range:
– vlan vlan-ID - vlan-ID, where the VLAN ID is 1 to 4094
– gigabitethernet module/{first port} - {last port}, where the module is always 0 (for
nonstacking-capable switches)
gigabitethernet stack member/module/{first port} - {last port}, where the module is always 0
(for stacking-capable switches)
– tengigabitethernet module/{first port} - {last port}, where the module is always 0 (for
nonstacking-capable switches)
tengigabitethernet stack member/module/{first port} - {last port}, where the module is
always 0 (for stacking-capable switches)
– port-channel port-channel-number - port-channel-number, where the port-channel-number
is 1 to 64.
Note When you use the interface ranges with port channels, the first and last port-channel
number must be active port channels.
• You must add a space between the first interface number and the hyphen when entering an
interface-range. For example, gigabitethernet1/0/1 - 4 is a valid range; gigabitethernet1/0/1-4 is
not a valid range.
• The VLAN interfaces must have been configured with the interface vlan command. The show
running-config privileged EXEC command displays the configured VLAN interfaces. VLAN
interfaces not displayed by the show running-config command cannot be used as interface-ranges.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 define interface-range macro_name
interface-range Define the interface-range macro, and save it in NVRAM.
• The macro_name is a 32-character maximum character string.
• A macro can contain up to five comma-separated interface
ranges.
• Each interface-range must consist of the same port type.
Step 3 interface range macro macro_name Select the interface range to be configured using the values saved in
the interface-range macro called macro_name.
You can now use the normal configuration commands to apply the
configuration to all interfaces in the defined macro.
Step 4 end Return to privileged EXEC mode.
Step 5 show running-config | include define Show the defined interface range macro configuration.
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.