Dell POWEREDGE M1000E - Manual (Page 294)

10-32
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
Configuring IEEE 802.1x Authentication
• Configuring MAC Authentication Bypass, page 10-54 (optional)
• Configuring NAC Layer 2 IEEE 802.1x Validation, page 10-55 (optional)
• Configuring Web Authentication, page 10-61
• Configuring a Web Authentication Local Banner, page 10-64
• Disabling IEEE 802.1x Authentication on the Port, page 10-65 (optional)
• Resetting the IEEE 802.1x Authentication Configuration to the Default Values, page 10-65
(optional)
Default IEEE 802.1x Authentication Configuration
Table 10-4 shows the default IEEE 802.1x authentication configuration.
Table 10-4 Default IEEE 802.1x Authentication Configuration
Feature Default Setting
Switch IEEE 802.1x enable state Disabled.
Per-port IEEE 802.1x enable state Disabled (force-authorized).
The port sends and receives normal traffic without IEEE
802.1x-based authentication of the client.
AAA Disabled.
RADIUS server
• IP address
• UDP authentication port
• Key
• None specified.
• 1812.
• None specified.
Host mode Single-host mode.
Control direction Bidirectional control.
Periodic re-authentication Disabled.
Number of seconds between
re-authentication attempts 3600 seconds.
Re-authentication number 2 times (number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state).
Quiet period 60 seconds (number of seconds that the switch remains in
the quiet state following a failed authentication exchange
with the client).
Retransmission time 30 seconds (number of seconds that the switch should
wait for a response to an EAP request/identity frame
from the client before resending the request).
Maximum retransmission number 2 times (number of times that the switch will send an
EAP-request/identity frame before restarting the
authentication process).