Dell POWEREDGE M1000E User Manual

Page 1075

43-7

Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide

OL-13270-03

Chapter 43 Configuring Web Cache Services By Using WCCP

Configuring WCCP

Beginning in privileged EXEC mode, follow these steps to enable the web cache service, to set a
multicast group address or group list, to configure routed interfaces, to redirect inbound packets received
from a client to the application engine, enable an interface to listen for a multicast address, and to set a
password. This procedure is required.

Note

Before configuring WCCP commands, configure the SDM template, and reboot the switch. For more
information, see

Chapter 9, “Configuring SDM Templates.”

Command

Purpose

Step 1

configure terminal

Enter global configuration mode.

Step 2

ip wccp {web-cache | service-number}
[group-address groupaddress]
[group-list access-list] [redirect-list
access-list] [password
encryption-number password]

Enable the web cache service, and specify the service number which
corresponds to a dynamic service that is defined by the application
engine. By default, this feature is disabled.

(Optional) For group-address groupaddress, specify the multicast group
address used by the switches and the application engines to participate in
the service group.

(Optional) For group-list access-list, if a multicast group address is not
used, specify a list of valid IP addresses that correspond to the application
engines that are participating in the service group.

(Optional) For redirect-list access-list, specify the redirect service for
specific hosts or specific packets from hosts.

(Optional) For password encryption-number password, specify an
encryption number. The range is 0 to 7. Use 0 for not encrypted, and use
7 for proprietary. Specify a password name up to seven characters in
length. The switch combines the password with the MD5 authentication
value to create security for the connection between the switch and the
application engine. By default, no password is configured, and no
authentication is performed.

You must configure the same password on each application engine.

When authentication is enabled, the switch discards messages that are not
authenticated.

Step 3

interface interface-id

Specify the interface connected to the application engine or the web
server, and enter interface configuration mode.

Step 4

no switchport

Enter Layer 3 mode.

Step 5

ip address ip-address subnet-mask

Configure the IP address and subnet mask.

Step 6

no shutdown

Enable the interface.

Step 7

exit

Return to global configuration mode. Repeat Steps 3 through 7 for each
application engine and web server.

Step 8

interface interface-id

Specify the interface connected to the client, and enter interface
configuration mode.

Step 9