Dell POWEREDGE M1000E User Manual
Page 841
36-55
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 36 Configuring QoS
Configuring Standard QoS
Step 10
policy-map policy-map-name
Create an interface-level policy map by entering the policy-map name,
and enter policy-map configuration mode.
By default, no policy maps are defined, and no policing is performed.
Step 11
class-map class-map-name
Define an interface-level traffic classification, and enter policy-map
configuration mode.
By default, no policy-map class-maps are defined.
If a traffic class has already been defined by using the class-map global
configuration command, specify its name for class-map-name in this
command.
Step 12
police rate-bps burst-byte [exceed-action
{drop | policed-dscp-transmit}]
Define an individual policer for the classified traffic.
By default, no policer is defined. For information on the number of
policers supported, see the
“Standard QoS Configuration Guidelines”
•
For rate-bps, specify average traffic rate in bits per second (b/s).
The range is 8000 to 1000000000.
•
For burst-byte, specify the normal burst size in bytes. The range is
8000 to 1000000.
•
(Optional) Specify the action to take when the rates are exceeded.
Use the exceed-action drop keywords to drop the packet. Use the
exceed-action policed-dscp-transmit keywords to mark down the
DSCP value (by using the policed-DSCP map) and to send the
packet. For more information, see the
Policed-DSCP Map” section on page 36-62
.
Step 13
exit
Return to policy-map configuration mode.
Step 14
exit
Return to global configuration mode.
Step 15
policy-map policy-map-name
Create a VLAN-level policy map by entering the policy-map name, and
enter policy-map configuration mode.
By default, no policy maps are defined.
The default behavior of a policy map is to set the DSCP to 0 if the
packet is an IP packet and to set the CoS to 0 if the packet is tagged. No
policing is performed.
Step 16
class class-map-name
Define a VLAN-level traffic classification, and enter policy-map class
configuration mode.
By default, no policy-map class-maps are defined.
If a traffic class has already been defined by using the class-map global
configuration command, specify its name for class-map-name in this
command.
Command
Purpose