Cooper Instruments & Systems DFI INFINITY B Ultra High Performance Digital Force Indicator - Manual (Page 66)

Press ‘RESET/ENTER’ 10) Display shows "StOREd" stored message momentarily and then advances to the
"StOP" Stop Bit setting submenu.
Press ‘RESET/ENTER’ 11) Display flashes "1b It" 1-Bit or previous setting.
Press ‘▲/MAX’
12) Scroll through and select 2 available following options: "1b It" (1-Bit) or "2b It"(2-Bit).
Press ‘RESET/ENTER’ 13) Display shows "StOREd" stored message momentarily and then advances to the
"bUS.FMt" Bus Format submenu.
26.2 bUS.FMt Enter COMMUNICATION BUS FORMAT Submenu:
Bus Format determines Communication Standards and Command/Data Formats for transferring information into and out
of the controller via the Serial Communication Bus. Bus Format submenus essentially determine how and when data can
be accessed via the Serial Communications of the device.
SUM.CHK
Press ‘RESET/ENTER’ 14) Display shows "SUM.CHk" Check Sum setting submenu. If necessary to select the
other available following Bus Format Setting submenus: "LN.FEEd", "ECHO", "StNd",
"MODE", and "HNd.SHk", use or press the ‘MENU’ button.
Press ‘RESET/ENTER’ 15) Display flashes "NO" No (checksum excluded) option as default or previous selection.
Press ‘▲/MAX’
16) Scroll through or select either two available options: "NO" to exclude or "yES" to
include the checksum with Input Reading Data.
LN.FEEd
Press ‘RESET/ENTER’ 17) Display shows "StOREd" stored message momentarily and then advances to the
"LN.FEEd" Line Feed setting submenu.
• Line Feed setting determines if data sent from the controller will have a Line Feed
appended to the end or following all ’s - useful for viewing or logging results on
separate lines when displayed on communications software at a computer.
Press ‘RESET/ENTER’ 18) Display flashes "NO" No (Line Feeds excluded) option as default or previous
selection.
Press ‘▲/MAX’ 19) Scroll through or select either two available options: "NO" to exclude or "yES" to
include the line feeds with Reading Data.
CF 156 61 M2544/N/0505