Cooper Instruments & Systems DFI INFINITY B Ultra High Performance Digital Force Indicator - Manual (Page 36)

11.0 INPUT TYPE MENU FLOWCHART: (INPUT)
12.0 INPUT TYPE SELECTION: (INPUT)
12.1 Input Type: (Thermocouple)
INPUt ENTER INPUT TYPE MENU:
Press ‘MENU’ 1) Display shows "INPUt" Input Menu.
Press ‘RESET/ENTER’ 2) Display flashes "VOLt" or previous stored input type.
Press ‘▲/MAX’
3) Scroll through the available following input type selection list. Display flashes:
"VOLt" (DC Voltage)
"CURRNt" (DC Current)
"bRIdGE" (Bridge)
"POt" (Potentiometer)
"tC" (Thermocouple)
"Rtd" (RTD).
If the displayed input type is "tC", press ‘RESET/ENTER’ to skip to Step 6 ("tC" stops
flashing).
t.C "t.C" THERMOCOUPLE SUBMENU:
Press ‘▲/MAX’ 4) Scroll through the available selection to "tC" (flashing).
Press ‘RESET/ENTER’ 5) Display shows "tC" again, but not flashing.
Press ‘RESET/ENTER’ 6) Display flashes previous thermocouple type selection. ie. "k tC" as default, (see Table
CF 156 31 M2544/N/0505