Cooper Instruments & Systems DFI INFINITY B Ultra High Performance Digital Force Indicator User Manual
Page 14
Figure 5-1. Meter Exploded View
Using Figure 5-1 as a guide, follow these simple instructions to open the unit:
IMPORTANT: Turn-off the power and input signals from the unit before proceeding. Failure to do so may result in
injury!
1. Remove the cover mounting screw that secures the rear protective cover to the unit, and remove the Rear Protective
Cover.
If you are simply wiring the unit – but not checking jumpers or installing or removing boards – this is as far as the unit
needs to be disassembled. Go to Section 5.2.1.
2. Remove all wiring connectors from the rear of the unit.
3. Remove the two thumbnuts that secure the case to the sleeve.
4. Remove the sleeve completely by sliding it back from the front bezel.
5. Using Figure 5-2 as a guide, bend the side-panel detents on the case outward and pull the board assembly out of the
case by the mounting screw stem.
From this point forward, these 5 steps are referred to as "Reveal the main board".
CF 156
9
M2544/N/0505