Cooper Instruments & Systems DFI INFINITY B Ultra High Performance Digital Force Indicator - Manual (Page 43)

Press ‘RESET/ENTER’ 22) Display shows "xxxxxx" some 6-digit number, represents the value of "INPUt 1" as
taken from live input source measurement for desired value.
Press ‘RESET/ENTER’ 23) Display shows "REAd 1" Item #2 of coordinate #1.
Press ‘RESET/ENTER’ 24) Display shows "xxxxxx" some 6-digit number with first digit flashing, represents the
value of "REAd 1" item #2 of coordinate #1.
Press ‘▲/MAX’ & ‘►/MIN’ 25) Use ‘MAX’ and ‘MIN’ buttons to enter new value of "REAd 1".
Press ‘RESET/ENTER’
26) Display shows "INPUt 2" Item #1 of coordinate #2. Continue to proceed with the
selection and value entry, for "INPUt 1" and "REAd 1" for "INPUt 2" and "REAd 2", (item
#1 and #2 of coordinate #2), similar to steps above.
Press ‘RESET/ENTER’ 27) Display advances to "UNt.tMP" Temperature Unit selection Submenu. If an item # of
coordinate # was prompted or modified, the controller will also show the "StOREd" stored
message momentarily.
MANUAL
Press ‘RESET/ENTER’ 28) "MANUAL" heading stops flashing.
Press ‘RESET/ENTER’ 29) Display shows "INPUt 1" Item #1 of coordinate #1.
Pressing ‘RESET/ENTER’ to sequence through:
"INPUt 1", Input 1 ‘s value
"REAd 1", Read 1 ‘s value
"INPUt 2", Input 2 ‘s value
"REAd 2", Read 2 ‘s value
headings for the desired selection and continue using ‘MAX’ and ‘MIN’ buttons to manually
enter or modify the values as described in the following section.
Press ‘RESET/ENTER’ 30) Display shows "xxxxxx" some 6-digit number with first digit flashing, represents the
value of "INPUt" item #1 of coordinate #1.
Press ‘▲/MAX’ & ‘►/MIN’ 31) Use ‘MAX’ and ‘MIN’ buttons to enter new value of "INPUt 1" item #1 of coordinate #1.
Press ‘RESET/ENTER’
32) Display shows "REAd 1". Continue the sequential items with ‘MAX’ & ‘MIN’ buttons to
select and enter values.
Press ‘RESET/ENTER’ 33) Display advances to "UNt.tMP" Temperature Unit selection Submenu. If an item # of
coordinate # was prompted or modified, the controller will also show the "StOREd" stored
message momentarily.
14.2 UNt.tMP Enter TEMPERATURE UNIT SELECTION Submenu:
1) To enter TEMPERATURE UNIT SELECTION Submenu if display shows "UNt.tMP"
(Second Item of "RdG.CNF" Menu).
Press ‘RESET/ENTER’ 2) Display shows flashing "C" (default) and front display shows °C accordingly at the
bottom right side or previous temperature Unit selection.
Press ‘▲/MAX’ 3) Scroll through the 3 supported selections to the Temperature Unit of your choice: "C",
"F" and "k" (°C, °F and °K units).
Press ‘RESET/ENTER’ 4) Display advances to "dEC Pt" Decimal Point Setting Menu. If a change was made,
the controller will also show the "StOREd" stored message momentarily.
14.3 dEC Pt Enter DECIMAL POINT CONFIGURATION Submenu:
CF 156 38 M2544/N/0505