ClearOne Interact Manual - Manual (Page 66)

Chapter 3: Compliance 61
FCC Part 68 Compliance
US: FBIBR00BINTERACT
Ringer Equivalence Number (REN): 0.0B(ac)
This equipment complies with Part 68 of the FCC Rules Requirements adopted by ACTA . The mixer unit of
this equipment contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If
requested, this information must be provided to your telephone company.
The REN is used to determine the number of devices that may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but
not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that
may be connected to the line, as determined by the total RENs, contact the telephone company to obtain
the maximum RENs for the calling area. The REN for this product is part of the product identifier that has the
format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g. 03 is a
REN of 0.3).
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice isn’t practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the
FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the telephone company will provide advance notice in
order for you to make the necessary modifications to maintain uninterrupted service.
This equipment uses an RJ11C jack that is used to connect this equipment to the premises wiring and telephone
network. This RJ11C jack complies with the applicable FCC Part 68 Rules and Requirements adopted by
the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. See installation instructions for details.
» WARNING: The country code must be set correctly in Console to ensure that the unit operates
properly when connected to the Telco network, and that it complies with the country’s Telco
requirements. Changing this code to a country other than the intended country of operation
might cause INTERACT devices to be non-compliant. 304.
If you experience problems with this equipment, contact ClearOne Communications, 5225 Wiley Post Way,
Suite 500, Salt Lake City, Utah 84116, or by phone at (800) 945-7730 for repair and warranty information. If the
equipment is causing harm to the telephone network, the telephone company may request that the equipment
be disconnected until the problem is resolved.
No user serviceable parts are contained in this product. If damage or malfunction occurs, contact ClearOne
Communications for instructions on its repair or return.
Connection to party line service is subject to state tariffs. Contact the state public utility commission, public
service commission or corporation commission for information. This equipment cannot be used on telephone
company provided coin service.
If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of
this equipment does not disable your alarm equipment. If you have questions about what will disable alarm
equipment, consult your telephone company or a qualified installer.
Electrical Safety Advisory
This equipment uses AC power which can be subjected to electrical surges, typically lightning transients which
are very destructive to customer terminal equipment connected to AC power sources. The warranty for this
equipment does not cover damage caused by electrical surge or lightning transients. To reduce the risk of this
equipment becoming damaged it is suggested that the customer consider installing a surge arrestor.