Serial commands, Connecting with telnet, How to connect with telnet – ClearOne Interact Manual User Manual
Page 28: Use the client of your choice, Telnet uses port 23, Onnecting, With, Elnet
Chapter 2: Getting Started 23
SERIAL COMMANDS
The
INTERACT Serial Commands
guide can be found as a separate document.
The document contains a list of applicable Serial Commands for the INTERACT AT and INTERACT Pro
models, along with their uses and applications.
Connecting with Telnet
Users can connect to any unit via RS-232 and Telnet. Available Telnet commands are the same as those
used in the Serial Command section of the INTERACT Serial Commands guide.
h
ow
To
C
onneCT
wiTh
T
elneT
:
• Use the Client of your choice
• Telnet uses Port 23
• The Username and Password are the same as used by INTERACT. The default username is “
clearone“
and the default password is “
interact” - both lowercase.
»
NOTE: The INTERACT Pro 8i cannot be controlled through RS-232 and Telnet.
Pin#
User Definable
Control
1
N
DCD
2
N
TXD
3
N
RXD
4
N
DTR
5
N
Ground
6
N
DSR
7
N
CTS
8
N
RTS
9
N
No Connection
»
NOTE: To avoid communication errors, ClearOne recommends using all nine pins when
connecting to the RS -232 port.