ClearOne Interact Manual - Manual (Page 29)

24 Technical Support: 800-283-5936
INTERACT AT
The ClearOne INTERACT AT is a mixer that interfaces with the MIC and MIC EX via an RJ-45 cable. It is
equipped with two (2) Line Inputs, two (2) Line Outputs, a 5-Watt Amplifier and Telephone Hybrid.
Features of the INTERACT AT include:
Front
A. On/Off hook indicator
B. Microphone Indicator: Indicators show which microphone channels are active
C. Input Metering: Shows current Input Level
D. USB 2.0-Compatible Input
Back
A. Telephone Interface: Connect an analog phone line to the INTERACT
B. RS-232 Control Port: Used to connect to the INTERACT Software or control from a 3rd-party controller
such as AMX or Crestron
C. Camera Control: Video System Control Architecture port used to control a VISCA compatible camera
D. Ethernet Port: 10/100 Mbps Ethernet port. The LEDs adjacent to the port indicate connection status
and packet traffic activity
E. MIC Pod Link-In Input: Input for the INTERACT MIC Pod accessory. The INTERACT MIC EX, INTERACT
COM and INTERACT COM-W can also be placed on this port
F. Playback/Record Input/Outputs: Left and right channel input and output RCA jacks used to connect
playback and recording devices
G. Line Input/Output: Mono line input and output RCA jacks
H. Speaker Outputs: Left and Right Push Terminals, 5-Watts/Channel, 8Ω
I. Power Adapter Input: 12 VDC 1.25 A
» WARNING: Use the Link In and Link Out ports with INTERACT Devices ONLY. Connecting any
other devices to the Link In and Link Out ports, including ClearOne Converge and Converge
Pro products, or Power Over Ethernet (PoE) devices, will result in severe equipment damage.