ClearOne Interact Manual - Manual (Page 65)

60 Technical Support: 800-283-5936
Chapter 3: Compliance
COMPLIANCE
» WARNING: The country code must be set correctly in the INTERACT software to ensure that
the unit operates properly when connected to the Telco network, and that it complies with the
country’s Telco requirements. Changing this code to a country other than the intended country
of operation might cause thr INTERACT Pro & INTERACT AT devices to be non-compliant.
FCC Part 15/ICES-003/RSS-210 Compliance
FCC ID:FBICOM (INTERACT COM-W)
FCC ID:FBIDIALER (INTERACT DIALER-W)
IC:1970A-COM (INTERACT COM-W)
IC:1970A-DIALER (INTERACT DIALER-W)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC rules and Industry Canada ICES-003. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case the user will be required to correct the
interference at his/her own expense.
This device complies with Part 15 of the FCC Rules and Industry Canada ICES-003. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received including interference that may cause undesired operation.
Changes or modifications not expressly approved by ClearOne Communications could void the user’s authority
to operate the equipment.
This equipment must be installed by qualified professionals or contractors in accordance with FCC Part 15.203
& IC RSS-210, Antenna Requirements. Do not use any antenna other than the one provided with the unit.
This device has been designed to operate with the antenna listed below, and has a maximum gain of 2.0 dB.
Antennas not included in this list of having a gain greater than 2.0 are strictly prohibited for use with this device.
The required antenna impedance is 50Ω.
Pulse Model W1030
To reduce potential radio interference to other users, the antenna type and its gain should be chosen so that the
Equivalent Isotropic Radiated Power (E.I.R.P.) is not more than that permitted for successful communication.
FCC/IC RF Radiation Exposure Statement
This equipment complies with the FCC/IC radiation exposure limits set forth for portable transmitting devices
operating in an uncontrolled environment. End users must follow the specific operating instructions for
satisfying RF exposure compliance.
• The equipment should only be used or installed at locations where there is normally at least a 20cm
separation between the antenna and all persons.
» NOTE: The DIALER-W contains an internal antenna while the COM-W uses an external
antenna.
• This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
• Changes or modifications not expressly approved by the party responsible could void the user’s authority
to operate this equipment.