ClearOne Interact Manual - Manual (Page 15)

10 Technical Support: 800-283-5936
USING THE DIALER
Managing Calls
Most phone specific functions, such as dialing a call or adding a phonebook entry, will be managed from the
wired or wireless dialer. Phonebook and dialer actions can be done through software as well.
T
o
a
nswer a
C
all
• Press on the dialer to answer the call. When there is an incoming call, the phone rings and the LEDs
on the microphones flash.
» Note: INTERACT can also be set to automatically answer calls using Menu options.
T
o
M
ake a
C
all
1. Press You will hear a dial tone.
2. Dial the number as you would on a standard phone.
The number appears on the LCD screen.
» Note: The dialer accepts a maximum of 44 characters.
No more than 44 characters can be entered.
T
o
p
re
-
dial a
C
all
1. Dial a phone number
You can press to delete the last digit entered in the pre-dialing string
2. Press to send the call.
» Note: The phonebook key will delete the entire dial string if you press it for two seconds.
Pressing and holding the pound (#) key for two seconds will insert a pause into the dialing
string.The duration of the pause is two seconds.
T
o
e
nd a
C
all
Press on the dialer to disconnect the call.
» Note: INTERACT can also be set to automatically disconnect calls using Menu options.
T
o
M
uTe
/u
nMuTe The
M
iCrophones
1. Press to mute the microphones.The microphone LEDs will illuminate red.
2. Press again to unmute microphones. The microphone LEDs will illuminate green.
» Note: This function mutes all microphones in the room. The microphone LEDs and the mixer
front panel LEDs light red when the microphones are muted.
T
o
u
se
s
peed
d
ial
• Press and hold the assigned speed dial number on the dial pad.
» Note: You can dial numbers 1-9 by pressing and holding the assigned number. To dial 10,
press and hold 0.