Rockwell Automation GV3000/SE AC Drive 1-20HP, 230VAC Ver. 6.04 Hdwe Ref, Install, Troubleshooting User Manual

Page 72

9-2

GV3000/SE 230 VAC 1-20 HP Drive, Hardware Reference Version 6.04

Figure 9.1 – DC Bus Voltage Terminals

9.4 Checking Out the Power Module with Input Power Off

Use the following procedure to check the drive's Power Module circuitry with power
off:

ATTENTION: DC bus capacitors retain hazardous voltages after input
power has been disconnected. After disconnecting input power, wait
five (5) minutes for the DC bus capacitors to discharge and then check
the voltage with a voltmeter to ensure the DC bus capacitors are
discharged before touching any internal components. Failure to
observe this precaution could result in severe bodily injury or loss of life.

Step 1. Turn off and lock out input power. Wait five minutes.

Step 2. Remove the drive's cover.

Step 3. Verify that there is no voltage at the drive's input terminals.

Step 4. Check the DC bus potential with a voltmeter as described in section 9.3 to

ensure that the DC bus capacitors are discharged.

Step 5. Disconnect the motor from the drive.

Step 6. Check all AC line and DC bus fuses.

Step 3. Verify that there is no voltage at the drive's input power terminals.

Step 4. Measure the DC bus potential with a voltmeter at the DC bus power

terminals while standing on a non-conductive surface and wearing
insulated groves (600 V). See figure 9.1.

Step 5. Once the drive has been serviced, reattach the drive's cover.

Step 6. Reapply AC input power.

–

(L1)

(L2)

(L3)

(T1)

(T2)

(T3)

DC BUS

VOLTS

–