Rockwell Automation GV3000/SE AC Drive 1-20HP, 230VAC Ver. 6.04 Hdwe Ref, Install, Troubleshooting - Manual (Page 13)

1-1 Becoming Familiar with the Manual
C
HAPTER
1
Becoming Familiar with the Manual
This chapter provides help in finding information in the manual and describes the
intended audience. Also included are references to related publications and
instructions on receiving assistance from Reliance Electric.
1.1 Finding Information
This instruction manual describes the GV3000/SE drive's Power Module and
regulator hardware. It does not cover the GV3000/SE software. For software
information, refer to the GV3000/SE 230 VAC 1-20 HP General Purpose (V/Hz) and
Vector Duty Drive Software Start-Up and Reference Manual (D2-3387).
As an aid in finding information in this manual, each chapter is briefly described below:
• Chapter 1 - Becoming Familiar with the Manual
Provides information on how the manual is organized and where
to find additional information.
• Chapter 2 - About the Drive
Identifies drive components and shows their locations.
• Chapter 3 - Planning Before Installing
Presents information that must be considered when planning a
drive installation.
• Chapter 4 - Mounting the Drive, Grounding, and Finding Wire Routing
Locations
Describes how to mount the drive and properly ground it.
• Chapter 5 - Installing Input Power Wiring
Describes incoming AC and DC line components and how to
properly connect them.
• Chapter 6 - Installing Output Power Wiring
Describes output AC line components and how to properly
connect them to the motor.
• Chapter 7 - Wiring the Regulator Board Terminal Strip
Provides information on the I/O wiring that connects to the
terminal strip on the Regulator board.
• Chapter 8 - Completing the Installation
Provides instructions on how to perform a final check of the
installation before power is applied.
• Chapter 9 - Troubleshooting the Drive
Describes the equipment that is needed to troubleshoot the drive
and how to measure DC bus voltage. A replacement part list is
also provided.