Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 88)

4-56 LiquiFlo 1.5 AC Drive, Software Reference Version 1.2
Enables/disables annunciation of the faults shown in figure 4.24.
Resets a fault and clears the fault queue.
Enables/disables a fault reset (clear faults) attempt from any source. This does not
apply to fault codes, which are cleared indirectly via other actions.
Elapsed hours since initial drive power up. This value will rollover to 0 after the drive
has been powered on for more than the maximum value shown.
238 Fault Config 1
Range: See figure 4.24
Default: See figure 4.24
Access: 0 Path: Utility>Faults
See also:
Figure 4.24 – Fault Config 1 (238)
1 x 1 0 0 0 0 x x x x x x x x x
10 0 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 =Enabled
0 =Disabled
x =Reserved
Bit #
Po
w
er Loss
UnderV
oltage
Motor Ov
erLd
Shear Pin AutRst T
ries
Decel Inhibit
Nibble 1 Nibble 2 Nibble 3 Nibble 4
240 Fault Clear
Range: 0 = Ready
1 = Clear Faults
2 = Clr Flt Que
Default: 0 = Ready
Access: 1 Path: Utility>Faults
See also:
241 Fault Clear Mode
Range: 0 = Disabled
1 = Enabled
Default: 1 = Enabled
Access: 1 Path: Utility>Faults
See also:
242 Power Up Marker
Range: 0.0000 to 4,294,967.2925 Hr [0.0001 Hr]
Default: Read Only
Access: 1 Path: Utility>Faults
See also: 244, 246, 248, 250
32