Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 31)

Programming Basics 3-5
3.3.2 Restricting Access to Other Parameter Levels
The LCD OIM provides the option to restrict access to other parameter levels. This
feature requires the use of a user-defined password when an attempt to change the
access level is made.
To set the access level password, select the Password icon from the main menu. See
figure 3.4. The password value can range from 1 to 9999. A value of 0 disables the
password (factory default). You must either select Logout or return to the process
display screen to activate the password.
When you enter the password, you can change access levels until you select Logout
or return to the process display screen, which re-activates the password. Refer to
section 2.8 for information about the process display screen.
Note that once the password is enabled, you will also be prompted to enter the
password to access the Set Acc Lvl PW option.
This option is not supported in the VS Utilities software.
If There is More Than One OIM Connected to the Drive
Note that setting or changing the access level password on one OIM will set or change
the access level password for all OIMs connected to the drive.
!
ATTENTION:It is the user’s responsibility to determine how to distribute
the access level password. Reliance Electric is not responsible for
unauthorized access violations within the user’s organization. Failure to
observe this precaution could result in bodily injury.
Figure 3.4 – Setting the Access Level Password
Auto Stopped
Main Menu
Password
P0: LiquiFlo 1.5
Password:
Set Acc Lvl PW
Set Wrt Prot PW
Set Access Lvl
Set Acc Lvl PW:
0 New Code:
Increase/decrease
value
Move placeholder
Highlight option Highlight Password icon
Password:
Set Wrt Prot PW
Logout
Set Acc Lvl PW
Highlight Logout
Activate password
Monitor Lang
>>