Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 16)

2-4 LiquiFlo 1.5 AC Drive, Software Reference Version 1.2
2.2.1 Key Descriptions
Table 2.1 – Key Functions
Key Function
Scroll through options or user function keys, move cursor to the left.
Scroll through options or user functions keys, move cursor to the right.
Scroll through options, increase a value, or toggle a bit.
Scroll through options, decrease a value, or toggle a bit.
Exit a menu, cancel a change to a parameter, or toggle between
program and process (user) display screens.
Enter a menu, select an option, or save changes to parameter value
Enable Hand (manual) reference control.
Release Hand (manual) reference control.
Stop the drive. Clear a fault if the OIM is the control source.
Start the drive if the OIM is the control source.
F1 though F4: Predefined or user-configured functions. The definition
of each key is shown directly above the key on the display. See item
➀
in figure 2.3.
!
ATTENTION:When switching from Auto to Hand, or Hand to Auto, the
drive will ramp to the reference level provided by the new source at the
rate specified in Accel Time 1 (140), Decel Time 1 (142), Accel Time 2
(141), or Decel Time 2 (143). Be aware that an abrupt speed change
may occur depending upon the new reference level and rate specified
in these parameters. Failure to observe this precaution could result in
bodily injury.
ESC/
PROG
HAND
AUTO
F1