Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 129)

Troubleshooting the Drive 5-15
5.6 Common Symptoms and Corrective Actions
Table 5.9 – Drive Does Not Start From Start, Run, or Jog Inputs Wired to the Terminal Block
Indication(s) Cause(s) Corrective Action
Flashing red
Ready LED. Drive is faulted. Clear fault:
• Press OIM stop key if that OIM is
control source.
• Cycle power.
• Set Fault Clear (240) to 1.
• Toggle terminal block stop or terminal
block reset digital input if terminal block
is kthe control source.
Incorrect
operation from
the terminal
block. Incorrect input wiring.
• 2-wire control requires
Run, Run Forward, or
Run Reverse input(s).
• 3-wire control requires
Start and Stop inputs
• Jumper from terminal
7 to 8 is required.
Wire inputs correctly and/or install
jumper.
Incorrect digital input
programming.
• Mutually exclusive
choices have been
made.
• 2-wire and 3-wire
programming may be
conflicting.
• Exclusive functions
(i.e, direction control)
may have multiple
inputs configured.
• Stop if factory default
and is not wired or is
open.
• Start or Run
programming may be
missing.
Program Digital In”x” Sel (361-366) for
correct inputs.
Logic Source Sel is not
set to Terminal Blk. Set Logic Source Sel to Terminal Blk.