Rockwell Automation 2755-DM9, -DM9E High Speed Decoder - Manual (Page 35)

Chapter 4
Configuring Your Decoder
4–8
-- SYMBOLOGY -- -------- LENGTHS -------- -------- SCANNER CONTROL --------
CODE 39: Yes 00 00 00 00 00 00 00 00 LASER-ON MODE: Continuous
I 2-OF-5: No 00 00 00 00 00 00 00 00 DECODE TRIGGER: Package Detect
CODE 128: No 00 00 00 00 00 00 00 00 CAPTURE COUNT: 2 (scans)
CODABAR: No 00 00 00 00 00 00 00 00 FIELDS/SCAN: 1
UPC-A: No FIELDS/PACKAGE: 1
UPC-E: No NO-READ TIMER: 0000 (msec)
EAN-8: No INTER-SCAN TIMER: 0000 (msec)
EAN-13: No MATCH COMPLETE: 1
---------MATCH CODE TABLE-------------- ----------- OUTPUTS [DISABLED]--------
1) CODE 39 N
None 0000
2) CODE 39 N None 0000
3) CODE 39 N None 0000
4) CODE 39 N None 0000
5) CODE 39 N None 0000
6) CODE 39 N None 0000
7) CODE 39 N None 0000
8) CODE 39 N None 0000
_______________________________________
Commands: ESC Change: SPACE Cursor Control: ARROWS
_______________________________________
Note: The two setup screens display the current operating parameters of the
decoder. Any changes made to the configuration will become effective
immediately with the exception of the host communication parameters. In
order for changes to the host port baud rate, stop bits, parity, host protocol, or
device address to take effect, you must save the changes to the decoder’s
EEPROM (SAVE command) and then restart. You can restart the decoder by
pressing the [5] key (Restart System) at the Select Operation menu, through a
host command, or by turning the power off and then back on.
In the following sections of this chapter we will provide a description of all
the options available on the two setup screens. We will also provide a
step-by-step programming example.
4) Reset Status and Counters- Pressing the [4] key at the operations menu
will reset the package counter, no-read counter, and output counters. Prior to
resetting the counters, the decoder will display a confirmation prompt:
RESET STATUS AND COUNTERS . . . Confirm (Y/N)
Press the [Y] key to confirm the reset. Pressing the [N] key will cancel the
reset function.
5) Restart System- Pressing the [5] key at the select operation menu will
reboot the decoder. This has the same effect as turning the power off and
then back on. Prior to restarting the system, the decoder will display a
confirmation prompt: