Rockwell Automation 1746-HSCE,D17466.5 High-Speed Counter Module User Manual
High-speed counter module
Table of contents
Document Outline
- Front Cover - High-Speed Counter Module User Manual
- Important User Information
- Summary of Changes
- Table of Contents
- Preface
- Chapter 1 - Module Overview
- Chapter 2 - Module Operation
- Chapter 3 - Installation and Wiring
- Compliance to European Union Directives
- Dip Switch and Jumper Locations
- SW2 Settings
- SW1 Settings
- JW1 Settings
- Installing the Module
- Important Wiring Considerations
- Input and Output Connections
- Removing the Terminal Block
- Wiring the Removable Terminal Block
- Encoder Selection
- Differential Encoder Wiring
- Single-Ended Encoder Wiring (Open Collector)
- Single-Ended Encoder Wiring (Sourcing)
- Single-Ended Wiring (Discrete Devices)
- Limit Switch Wiring (24V dc Hard Contact)
- Limit Switch Wiring (12V dc Hard Contact)
- Limit Switch Wiring (5V dc Solid State)
- Chapter 4 - Configuration and Programming
- Configuration Worksheets
- Dynamic and Static Parameters
- M0 File Words - Range and Rate Modes
- Output Data File Word - Range and Rate Modes
- Input Data File Words - Range and Rate Modes
- M0 File Words - Sequencer Mode
- M0:e.0 Output Source Select
- M0:e.1 Setup and Control Word
- M0:e.2 and M0:e.3/0-7 Valid Steps (Dynamic)
- M0:e.3 /8-15 Initial Outputs (Dynamic)
- M0:e.4 through M0:e.15-Step 1 through 24 Outputs (Dynamic)
- M0:e.16 Rate Period (Dynamic)
- M0:e.17 through M0:e.40 Step 1 through 24 Presets (Dynamic)
- M0:e.41 Maximum Count (Static) / Reset Value (Dynamic)
- Output Data File Word - Sequencer Mode
- Input Data File Words - Sequencer Mode
- Chapter 5 - Start-Up, Operation, and Troubleshooting
- Chapter 6 - Application Examples
- Appendix A - Specifications
- Appendix B - M0 and M1 Files
- Appendix C - Differential Encoder Information
- Appendix D - Range/Rate Mode Configuration Worksheets
- Appendix E - Sequencer Mode Configuration Worksheets
- Glossary
- Index
- Back Cover