Rockwell Automation 1769-SM2 Compact I/O DSI/Modbus Communication Module - Manual (Page 132)

8-2 ControlLogix w/1769-ADN DeviceNet Example Ladder Program
Explicit messaging (parameter read/write) capability varies between the
RSLogix software packages and controllers:
•
At the time of publication, the 1769-ADN does NOT have explicit
messaging capability. Refer to ADN documentation for possible
future explicit messaging support.
Figure 8.1 Example ControlLogix/1769-ADN DeviceNet Adapter in a Single Mode
System Arrangement
To use RSNetWorx for DeviceNet, you must first set up a driver in
RSLinx. RSLinx Classic, in all its variations (Lite, Gateway, OEM, etc.),
is used to provide a communication link between the computer, network,
and controller. RSLinx Classic requires its network-specific driver to be
configured before communications are established with network devices.
To configure the RSLinx driver:
1. Start RSLinx and select Communications > Configure Drivers to
display the Configure Drivers screen.
2. In the Available Drivers pull-down box, select “DeviceNet Drivers
(1784-PCD/PCIDS, …drivers” and then click Add New… to display
the DeviceNet Driver Selection screen.
3. Select the PC communication card (1770-KFD, 1771-SDNPT, etc.)
for connection of your computer to the network and then click
Select.
4. Configure the driver for your computer and network settings and
click OK.
PowerFlex 4/40 Drives
CH1
CH2
CH3
1769-ADN
DSI
MODULE CH1 CH2 CH3 MS IO NS DIAG
DeviceNet
C H 1
C H 2
C H 3
Using RSLinx Classic