Rockwell Automation 1762-Lxxxx MicroLogix 1200 Programmable Controllers - Manual (Page 32)

Publication 1762-UM001G-EN-P - March 2011
2-18 Install Your Controller
Use DIN rail end anchors (Allen-Bradley part number 1492-EA35 or
1492-EAH35) for vibration or shock environments. The following illustration
shows the location of the end anchors.
Mount on Panel
Use the dimensional template shown below to mount the module. The
preferred mounting method is to use two M4 or #8 panhead screws per
module. Mounting screws are required on every module.
TIP
1762 expansion I/O must be mounted horizontally as
illustrated.
TIP
For environments with greater vibration and shock
concerns, use the panel mounting method described
below, instead of DIN rail mounting.
End Anchor
End Anchor
90
(3.54) 100
(3.94)
40.4
(1.59)
A
B
40.4
(1.59)
14.5
(0.57)
MicroLogix
1200 1762 I/O 1762 I/O 1762 I/O
For more than 2 modules: (number of modules - 1) x 40 mm (1.58 in.)
NOTE: All dimensions are in mm (inches).
Hole spacing tolerance: ±0.4 mm (0.016 in.).
A = 95.86mm (3.774 in.)
1762-L24AWA, 1762-L24BWA, 1762-L24BXB
1762-L24AWAR, 1762-L24BWAR, 1762-L24BXBR
B = 145.8 mm (5.739 in.)
1762-L40AWA, 1762-L40BWA, 1762-L40BXB
1762-L40AWAR, 1762-L40BWAR, 1762-L40BXBR