Rockwell Automation 1336T ControlNet Frn1.02 Rev 1.5 - Manual (Page 174)

6–32 Parameters
Publication 1336 FORCE–5.18 ––March, 1999
413 Clear Fault Mask
[Clr Fault Mask]
Clr Fault Mask controls which ports can generate a
clear fault command.
Parameter Number 413
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units Bits
Factory Default 0
Minimum Value 0
Maximum Value 0FE Hex
File – Group Communications I/O – SCANport Masks
Enums Bit 1 = Port 1 Bit 2 = Port 2 Bit 3 = Port 3 Bit 4 = Port 4
Bit 5 = Port 5 Bit 6 = Channel A Bit 7 = Channel B
414 Reset Drive Mask
[Reset Drive Mask]
Reset Drive Mask controls which ports can reset a
fault.
Parameter Number 414
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units Bits
Factory Default 0
Minimum Value 0
Maximum Value 0FE Hex
File – Group Communication I/O – SCANport Masks
Enums Bit 1 = Port 1 Bit 2 = Port 2 Bit 3 = Port 3 Bit 4 = Port 4
Bit 5 = Port 5 Bit 6 = Channel A Bit 7 = Channel B
415 Local Mask
[Local Mask]
Local Mask controls which ports are allowed to take
exclusive control of drive logic commands except
Stop. (Stop is accepted from any device regardless
of who has control.) You can only take exclusive
local control while the drive is stopped.
Parameter Number 415
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units Bits
Factory Default 0
Minimum Value 0
Maximum Value 0FE Hex
File – Group Communications I/O – SCANport Owners
Enums Bit 1 = Port 1 Bit 2 = Port 2 Bit 3 = Port 3 Bit 4 = Port 4
Bit 5 = Port 5 Bit 6 = Channel A Bit 7 = Channel B
416 SCANport Default Reference
[SP Default Ref]
SP Default Ref defines the default reference to be
used when the drive is powered up. You can
change the value of this parameter, but the change
is only accessed when the drive is powered up.
Parameter Number 416
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units None
Factory Default 2
Minimum Value 1
Maximum Value 7
File – Group Velocity Torque – Velocity Ref
Enums Bit 1 = Xref1 Bit 2 = Preset1 Bit 3 = Preset2 Bit 4 = Preset3
Bit 5 = Preset4 Bit 6 = Preset5 Bit 7 = Xref2