Rockwell Automation 20-COMM-D DeviceNet Adapter Series B FRN 2.xxx - Manual (Page 19)

20-COMM-D DeviceNet Adapter User Manual
Publication 20COMM-UM002G-EN-P
Chapter 2
Installing the Adapter
This chapter provides instructions for installing the adapter in a PowerFlex
7-Class drive. The 20-COMM-D Series B adapter, firmware revision 2.xxx
or later, can also be installed in a DPI External Comms Kit. In this case, see
Chapter 8 or the 20-XCOMM-DC-BASE Installation Instructions,
publication 20COMM-IN001, supplied with the kit.
Preparing for an Installation Before installing the adapter, do the following:
• Read the DeviceNet Media Design and Installation Guide, publication
DNET-UM072.
• Read the DeviceNet Starter Kit User Manual, publication
DNET-UM003.
• Verify that you have all required equipment. See Required Equipment on
page 1-3 .
Topic Page
Preparing for an Installation 2-1
Setting the Node Address Switches 2-2
Setting the Data Rate Switch 2-3
Connecting the Adapter to the Drive 2-4
Connecting the Adapter to the Network 2-7
Applying Power 2-8
Commissioning the Adapter 2-10
!
ATTENTION: Risk of equipment damage exists. The adapter
contains electrostatic discharge (ESD) sensitive parts that can be
damaged if you do not follow ESD control procedures. Static
control precautions are required when handling the adapter. If you
are unfamiliar with static control procedures, see Guarding
Against Electrostatic Damage, publication 8000-4.5.2.