Rockwell Automation 20-COMM-D DeviceNet Adapter Series B FRN 2.xxx - Manual (Page 13)

20-COMM-D DeviceNet Adapter User Manual
Publication 20COMM-UM002G-EN-P
Chapter 1
Getting Started
The adapter is intended for installation into a PowerFlex 7-Class drive and
is used for network communication. The 20-COMM-D Series B adapter,
firmware revision 2.xxx or later, can also be installed in an External DPI
Comms Kit (20-XCOMM-DC-BASE).
For PowerFlex 750-Series drives, we recommend using the 20-750-DNET
DeviceNet option module instead of the 20-COMM-D adapter. However,
this manual does include information on using the 20-COMM-D adapter
with PowerFlex 750-Series drives—but there are operating limitations. For
details, see
Compatible Products on page 1-3 .
Components
Topic Page
Components 1-1
Features 1-2
Compatible Products 1-3
Required Equipment 1-3
Safety Precautions 1-5
Quick Start 1-6
Item Part Description
➊ Status Indicators Three status indicators that indicate the status of the DPI, adapter,
and network connection. See Chapter 7 , Troubleshooting .
➋ DPI Connector A 20-pin, single-row shrouded male header. An Internal Interface
cable is connected to this connector and a connector on the drive.
➌ DeviceNet Connector A 5-pin connector to which a 5-pin linear plug (supplied with
adapter) can be connected for the DeviceNet network cable.
➍ Node Address Switches Switches to set the node address. See Setting the Node Address
Switches on page 2-2 .
➎ Data Rate Switch Switch to set the DeviceNet data rate at which the adapter
communicates. See Setting the Data Rate Switch on page 2-3
➊
➋
➌
➍
➎