Opticon H22 - Manual (Page 6)

6
Additional Battery Information
Please read the following information carefully to understand battery safety.
• Do not disassemble or open, crush, bend or deform, puncture, or shred the battery.
• Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or
expose to water or other liquids, or expose to fire, explosion, or other hazard.
• Only use the battery for the system for which it was specified,
• Only use the battery with charging system that has been qualified with the system per this
standard. Use of an unqualified battery or charger may present a risk of fire, explosion, leakage, or
other hazard.
• Do not short circuit a battery or allow metallic or conductive objects to contact the battery
terminals.
• Battery usage by children should be supervised.
• Avoid dropping the phone or battery. If the phone or battery is dropped, especially on hard
surface, and the user suspect damage, take it to service center for inspection.
• Improper battery use may result in a fire, explosion, or other hazard.
• Seek medical advice immediately if a battery has been swallowed
• Do not leave the battery where the temperature is 60˚C (140˚F) or more.
• Do not solder lead directly to the battery body.
• Do not heat nor solder the terminals of the battery.
• Do not charge beyond the condition which described on the delivery specification.
• Do not inverse charge the battery.
• In the event the Battery Pack leaks and the fluid gets into one's eye, do not rub the eye. Rinse
well with water and immediately seek medical care. If left untreated, the battery fluid could cause
damage to the eye.
• Charge the battery at least every six months. An excessive over-discharge may cause an
abnormal chemical reaction, which may result in acid leakage or fire of the battery.
• Despite being rechargeable, the battery has a limited life span. Replace it when usage time
becomes short.
Safety of Laser Products: International Standards Laser Class 2
This product complies with JIS C6802: 2005 Class 2, IEC60825 -1+A2: 2001 Class 2 and 21CFR
1040.10 and 1040.11 except for deviations pursuant to Laser Notice No.50, dated June 24, 2007.
Class 2 Laser devices are not considered to be hazardous when used for their intended purpose.
Use of controls, adjustment of procedures other than those specified herein may result in hazardous
laser light exposure. Do not look directly into the light beam with optical instruments; it may pose an
eye hazard.