Lenze E84DSxxx - Manual (Page 542)

15 Parameter reference
15.2 Parameter list | C00401
542
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00401
C00408
Parameter | Name:
C00401 | CANxInOut: Inversion
Data type: UNSIGNED_16
Index: 24174
d
= 5E6E
h
This parameter serves to invert the control/status bits of the CAN port blocks.
 System bus "CAN on board": Port blocks
Setting range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Active Bit set = bit is inverted
... ...
Bit 15 Active
Subcodes Lenze setting Info
C00401/1 0 Inversion of LP_CanIn1.bCtrl1_B0...15
C00401/2 0 Inversion of LP_CanOut1.bState1_B0...15
C00401/3 0 Inversion of LP_CanIn2.bIn1_B0...15
C00401/4 0 Inversion of LP_CanOut2.bOut1_B0...15
C00401/5 0 Inversion of LP_CanIn3.bIn1_B0...15
C00401/6 0 Inversion of LP_CanOut3.bOut1_B0...15
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C00408 | LP_CanIn mapping selection
Data type: UNSIGNED_8
Index: 24167
d
= 5E67
h
Selection of the mapping source for port blocks LP_CanIn1...3
 System bus "CAN on board": Port blocks
Selection list Info
0 CanIn CanIn
1 Par.C409 Mapping configured in C00409
Subcodes Lenze setting Info
C00408/1 0: CanIn Mapping selection LP_CanIn1
C00408/2 0: CanIn Mapping selection LP_CanIn2
C00408/3 0: CanIn Mapping selection LP_CanIn3
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1