INFICON Guardian EIES Controller - Manual (Page 29)

2 - 5
IP
N 07
4-
51
7-
P1
D
Guardian Co-Deposition Controller Operating Manual
WARNING
Maintain adequate insulation and physical separation of
sensor, detector, and I/O wiring from hazardous voltages.
WARNING
Relay contacts are rated for 30 V (dc) maximum duty. Any
customer supplied relay contact circuit must be fused at
not more than 5A if the circuit is capable of supplying
more than 5A, including the available short circuit
current.
2.2.5 QCM Option Installation
If an SQM-242 or Q-pod will be used for calibration or control, follow its Operating
Manual to install the QCM software and sensor(s).
For accurate rate calibration, locate the QCM sensor(s) in the vacuum chamber so
that the QCM sensor(s) receives a representative sample of the materials being
deposited.
2.3 EIES Software
Leave the Guardian Controller power OFF while you become familiar with the EIES
program. This section will introduce the concepts necessary to operate the EIES-IV
Guardian system.
2.3.1 Software Installation
Insert the INFICON Program Disk into your CD-ROM drive. The Products Menu
should appear after a few seconds, see
Figure 3-2 on page 3-3 . If not, open
Windows Explorer and run the UtilityDisk.exe program on the CDROM.
On the Products Menu, click EIES-IV Guardian. When EIES software installation
finishes, you may be prompted to restart your computer.