Eppendorf Galaxy CO2 Sensor - Manual (Page 95)

Stacking stand installation
Galaxy ® 170 R/170 S CO
2
Incubators
English (EN)
95
1. At least two persons are needed to very carefully tip the first incubator forward on its front feet, until the
rear castors are accessible. Hold the incubator steady.
2. Utilizing a third person and using a flat-bladed screwdriver, remove the rear castors from the bottom of
the incubator.
Abb. 13-1: Castor Removal
Fig. 13-1: Castor Removal
3. In place of the castors, fit the feet to the rear of the incubator (see the Figure below).
CAUTION! Personnel injury and equipment damage!
 Four people are required to safely lift a Galaxy 170 incubator.
 When lifting, be sure to use the lifting handles provided with the incubator.
 NEVER lift the incubator by the door as this may cause damage.
CAUTION! Equipment Damage!
 The illustration below is for reference only. Never turn the incubator upside down.
A third person should be used to remove the rear castors in the next step.