Eppendorf Galaxy CO2 Sensor - Manual (Page 33)

Operating controls and function for Galaxy 170 R Incubator
Galaxy ® 170 R/170 S CO
2
Incubators
English (EN)
33
6.3 Referencing the CO
2
sensor with Auto-Zero
Prior to using the incubator, you should manually perform a CO
2
Auto-Zero (see PROGRAMMABLE CO
2
AUTOZERO on p. 34):
1. Perform a CO
2
Auto-Zero by pressing the USER function key (see PROGRAMMABLE CO
2
AUTOZERO on
p. 34), selecting the PROGRAMMABLE CO
2
AUTOZERO, and pressing the START key.
2. The incubator will display a countdown as the Auto-Zero is running.
3. When the countdown is complete, the incubator is ready to use.
6.4 USER settings
In the USER screen, you can adjust the features called out on the screen.
Abb. 6-2: USER SETTINGS screen
Fig. 6-2: USER SETTINGS screen
This section explains each of the USER screen features. There are other USER options that may be
displayed on screen if they are installed on your incubator. For a list of available options (see Available
options on p. 64).
If the access code has been misplaced, you will be unable to make changes to your incubator’s
settings. Contact customer service or your service representative for instructions on how to
regain access to your incubator.
1 Use the and direction keys to move the
cursor
2 Use the ENTER function key to select an option
2
1