Eppendorf Galaxy CO2 Sensor - Manual (Page 22)

Installation
Galaxy
® 170 R/170 S CO
2
Incubators
English (EN)
22
4.3 Unpacking the incubator
1. Install the four lifting handles into the tapped holes on both sides of the incubator.
Abb. 4-1: Installing lifting handles
Fig. 4-1: Installing lifting handles
2. Carefully move the incubator to its operational location using lifting handles.
Silicone rubber suction feet are supplied for non-slip application.
3. Remove all internal packaging.
4. Remove the four lifting handles from the incubator and store for future use.
4.4 Initial setup
1. Place the silicone rubber suction feet onto the incubator’s adjustable feet.
2. Place two rubber shelf rack feet, and one shelf rack spacer onto each shelf rack (see Fig. 4-2 on p. 23).
3. Place the two shelf racks inside the chamber. Ensure that the cushioned tubing spacers are snug against
the side walls; these spacers allow clearance for the shelves.
CAUTION! Risk of personal injury
 At least four people are required to safely lift the incubator.
NOTICE! Risk of material damage
 Never try to lift the incubator by its door; this would cause permanent damage to the
incubator.
1 Access port 2 Lifting handles
Keep silicone rubber suction feet installed at all times.
1
2