Eppendorf Galaxy CO2 Sensor - Manual (Page 26)

Installation
Galaxy
® 170 R/170 S CO
2
Incubators
English (EN)
26
4.5 Making connections
1. Remove sensor (CO
2
, O
2
, and RH) protective cover (option dependant), and store for future use.
2. Remove gas inlet connector protection cap.
WARNING! Risk of personal injury
 Elevated levels of CO
2
may be found in and around the operating area of the CO
2
incubator.
 Wear personal protective equipment (PPE).
WARNING! Danger due to incorrect power supply
 Only connect the device to voltage sources that meet the requirements on the name plate.
 Only use sockets with a protective earth (PE) conductor and suitable power cable.