Eppendorf Galaxy CO2 Sensor - Manual (Page 93)

Stacking stand installation
Galaxy ® 170 R/170 S CO
2
Incubators
English (EN)
93
13 Stacking stand installation
13.1 Intended use
The stacking stand is designed for two Galaxy 170 incubators to be stacked on top of each other. The stand
can also be used to stack two Galaxy Plus series (not available in North America) incubators or any
combination of a Galaxy Plus model with a Galaxy 170. For optimum stability, if a 170 incubator is being
stacked with another Galaxy model, the 170 should be on the bottom.
13.2 Warnings for intended use
Before using the stacking stand, read this entire section and observe the following general safety
instructions.
13.3 General description
The stacking stand is designed for two Galaxy 170 incubators to be stacked on top of each other. The stand
can also be used to stack two Galaxy Plus series (not available in North America) incubators or any
combination of a Galaxy Plus model with a Galaxy 170. For optimum stability, if a 170 incubator is being
stacked with another Galaxy model, the 170 should be on the bottom. There is a lower and upper stacking
frame kit available.
13.3.1 Ordering options
The following Table lists the options available for the stacking stand when ordering. Contact Eppendorf
sales for ordering information.
WARNING! Personnel injury and equipment damage!
 Great care should be taken when moving the stacked incubators. Hazards, including
uneven surfaces and obstructions, may cause the stacked assembly to topple, potentially
injuring personnel.
CAUTION! Personnel injury and equipment damage!
 Four people are required to safely lift a Galaxy 170 incubator.
 When lifting, be sure to use the lifting handles provided with the incubator.
 NEVER lift the incubator by the door as this may cause damage.
Description
Lower and Upper Stacking Frame Kit
Upper Stacking Frame only
Lower Stacking Frame only