Eppendorf Innova 43R Incubator Shakers - Manual (Page 58)

58
Innova 43 & 43R Incubator Shakers  M1320-0050 Operating manual
3. Remove the two thumbscrews from the diffuser holder.
Figure 28: Replacing Photosynthetic Lamps
4. Remove the diffuser by placing a finger underneath and rotating the diffuser in the
slot at the back of the photosynthetic light assembly. All 9 lamps should now be
accessible to you.
5. To remove the lamp for replacement, rotate the lamp 90º, taking care to support the
lamp before it drops down.
6. To replace the lamp, orient the pins of the new lamp vertically. Simultaneously,
gently press both sides of the lamp into the slots.
7. Rotate the new lamp 90º. The lamp should catch in the holders on both ends. Make
sure both ends are secure.
8. Put the diffuser back in place, reinstalling the diffuser holder with its two
thumbscrews.
9.7 Adjusting Lid Tension
WARNING!
The following procedures are provided for your information only.
Do not attempt to perform these service interventions yourself unless you
are an authorized service technician.