Eppendorf Innova 43R Incubator Shakers - Manual (Page 44)

44
Innova 43 & 43R Incubator Shakers  M1320-0050 Operating manual
7. Turn the Knob to highlight the RPM setting ( Off in the sample screen above),
then click the Knob in. The field will flash.
8. Turn the Knob to select the desired shaking speed (25 to 400 RPM) for this
time period, then click the Knob in to save the setting. We will set Step 1
speed to 150 RPM (see Figure 23).
9. If you do not have the optional UV
lamp, skip this step. If you have the UV lamp
(default setting is Off ) and you wish to have it on during the time period you
have set, use the Control Knob to select the field, click the Knob to select the
field (it will flash), turn the Knob to select
On , then click the Knob in to save
the setting. In our sample Step 1 (see Figure 23), however, UV remains Off .
10. If you do not have the optional GRO
lamps, skip this step. If you have the
photosynthetic lamps (default setting is Off ) and you wish to have them on
during the time period you have set, use the Control Knob to select the field,
click the Knob to select the field (it will flash), turn the Knob to select
On ,
then click the Knob in to save the setting. In our sample Step 1 (see Figure
18), however,
GRO remains Off .
NOTE:
DO NOT select “Save” yet!
11. To program Step 2 (see sample screen in Figure 23): use the Control Knob to
highlight the arrows at the bottom left of the screen. Click the Knob to make
the arrows flash, then turn the Knob to the right until Step 2 appears. Click
the Knob in to work in this screen, and repeat Steps 3-10.
Figure 23: Program 1 – Step 2
PRG1 - STEP 01 02
Time 08:00 03:00
ºC 37.0 40.0
RPM 150 225
UV Off Off
GRO Off Off
 Save Cancel
1 Current step number
1