Eppendorf Innova 43R Incubator Shakers - Manual (Page 15)

15
New Brunswick Operating manual
5 5 F F
E E A A T T U U R R E E S S
5.1 Controls
Figure 3: Front Panel (detail)
1 Shaking Start/Stop switch 3 RS-232 port 5 Control knob
2 Display 4 Power switch

START/STOP
SWITCH This switch is used to start or stop the shaker. It will also
activate the timer when a timed run is desired. If the
shaker is stopped and restarted, the timer automatically
returns to the beginning of a run.
 CONTROL KNOB This knob is multifunctional. It is used to change
screens, and to select and change operating conditions.
 RS-232 PORT See Section 5.8 for details.

POWER SWITCH
This rocker switch is a circuit breaker that turns power on
and off to the entire Innova 43/43R.
NOTE:
In addition to the power switch, the power cord is also used to conduct
power or to break the power circuit to the shaker. Whenever power to the
shaker may be a hazard (during cleaning, maintenance or service work), be
sure to disconnect the power cord from the electrical outlet.
4
1
2
5
3