Eppendorf Innova 43R Incubator Shakers - Manual (Page 43)

43
New Brunswick Operating manual
2. Turn the Knob until the field says New . Click the Knob in to select this
mode. The screen for Program 1 - Step 1 will open (see Figure 22):
Figure 22: Program 1 – Step 1
PRG1 - STEP -- 01
Time 00:00
ºC 20.0
RPM Off
UV Off
GRO Off
 Save Cancel
1 Step number
2 Use “Cancel” to leave the programming mode without saving any new settings.
3 Use “Save” to leave the programming mode and save all new settings. Do NOT use
“Save” until the programming is complete.
4 Use these arrows to scroll through the programming steps.
NOTE:
If your shaker is not equipped with these optional features, “UV” and “GRO”
will appear with the word “Off” in this screen but will not be programmable.
3. Turn the Knob to highlight the Time setting (00:00 in the sample screen
above), then click the Knob in. The field will flash.
4. Turn the Knob until the desired running duration for this step (from 00:01,
which means one minute, to 99:59) appears, then click the Knob in to save the
setting. We will set Step 1 time to eight hours for this example (see Figure 23).
5. Turn the Knob to highlight the ºC temperature setting ( 20.0 in the sample
screen above), then click the Knob in. The field will flash.
6. To set the temperature desired ( ºC from 4.0 to 80.0) for the time period you
have set, turn the Knob (left to decrease, right to increase). When the desired
value appears, click the Knob in to save the setting. We will set Step 1
temperature to 37.0ºC (see Figure 23).