3p p – Eppendorf Innova 43R Incubator Shakers User Manual
Page 10
10
Innova 43 & 43R Incubator Shakers
M1320-0050
Operating manual
3
3
P
P
R
R
E
E
P
P
A
A
R
R
I
I
N
N
G
G
T
T
H
H
E
E
L
L
O
O
C
C
A
A
T
T
I
I
O
O
N
N
3.1 Physical
Location
It is essential that the instrument be situated in an area where there is sufficient space for
the shaker to clear walls and potential obstructions during operation. The surface on
which the unit is placed must be smooth, level, and able to support the shaker under full
load operating conditions.
CRUSH WARNING!
Do not attempt to lift the Innova 43/43R by hand.
Always use a lifter or other suitable equipment when raising or handling
the shaker.
NOTE:
The Innova 43/43R has casters and leveling feet. When you need to move
the shaker across the floor, make sure the feet are raised enough so that the
casters can roll freely without scraping the floor with the feet. At all other
times, make sure the feet are down, to avoid any unintended rolling.
3.2 Environment
The shaker is designed to operate optimally in the following ambient conditions:
10º to 35°C
20 to 80% Relative Humidity (non-condensing)
3.3 Electrical
Requirements
The Innova 43/43R can be equipped to run on:
100 Volts, 50 or 60 Hz, 1500 VA maximum
120 Volts, 60 Hz, 1500 VA maximum
230 Volts, 50 Hz, 1500 VA maximum
Check your shaker’s Electrical Specification Plate (located on the back of the shaker) to
be sure the electrical requirements of your shaker match the output of your electric
supply. If they do not match, contact your Eppendorf representative.