Eppendorf Innova 43R Incubator Shakers - Manual (Page 42)

42
Innova 43 & 43R Incubator Shakers  M1320-0050 Operating manual
7.5 Programming the Shaker
7.5.1 Timer Only
By setting an HRS setpoint in the DISP or SUMM screen, the shaker may be set to
automatically stop after a preset time period of 0.1 to 99.9 hours.
If the time is set to 0.0, the shaker will operate continuously until either the lid is
opened or the Start/Stop button is pushed.
7.5.2 Programmed Steps
The resident software for the Innova 43/43R can store up to four programs, each
having as many as 15 steps. Each step can be programmed in one-minute
increments, for total periods of one minute up to 99 hours 59 minutes each.
To enter the programming mode, use the Control Knob to select the PROG screen
(see Figure 21, repeated below). At this point, you can Run a program, Edit a
program, generate a New program or turn a program Off . Off is the default mode.
Figure 21: Programs Screen
PROGRAMS
Program 1 : Off
Program 2 : Off
Program 3 : Off
Program 4 : Off
PROG Th 16:23
7.5.3 Creating a Program
To write a New program:
1. Use the Control Knob to highlight the mode of Program 1 (in our sample
screen, Figure 21, it is Off ), then click the Knob in. The selected field begins
to flash.